Relling the Pro M102/MFP M130, Pro M104/MFP M132 Black Toner Cartridge

Refill fits: CF217A, CF218A
Required Tools: Toner approved vacuum, A small Phillips head screw driver.
Supplies Required: Toner for use in HP LaserJet Pro M102, MFP M130 (17A cartridge), Lint free cloth.

1. With the developing roller facing you and the gear box to the right, remove the two screws from the end cap and carefully work this end cap free from the cartridge. See figures 1 & 2
   

   Figure 1

   

   Figure 2

2. Remove the developing roll by sliding it out from the right side holder. You can use compressed air to clean this roller. Do not use any type of liquid on this roller. See figure 3
   

   Figure 3

3. Clean out all the old toner from the cartridge using a toner approved vacuum. Do not remove the dortor blade due to you the gap measurement that HP has set for this cartridge.
   

   Figure 4

4. You can now fill the cartridge with HP LaserJet Pro M102, MFP M130 toner. See figure 5
   

   Figure 5

5. Install the developer roller back into the cartridge. Note: While installing the developer roller, hold the roller in a slight angle while pushing the roller into place. If roller is not falling into place you might have to twist it as you install. See figures 6
   

   Figure 6

6. Line up the developing roller and gear on the end cap and slide it back onto the toner cartridge. Install the two screws and you are done. See figure 7
   

   Figure 7

Note: This cartridge has a chip and it will let the printer know when toner is low. It will keep running and the machine will never stop. After you refill the cartridge the machine will still run but still say toner very low.

This article is contributed by Color Imaging Inc.
Email any questions to sales@colorimaging.com or call 1-800-783-1090 x300.