Model Focus: HP 4500 Service mode: • Hold ITEMS and (+) buttons at power up until the three lights remain solid • Release, then press MENU (right side) then SELECT • Printer should display SERVICE MODE • Scroll until printer reads "TRANSFER COUNT" or "FUSER COUNT" • Set all digits to zero CLJ 4550 • Scroll MENU button to resets menu then press SELECT button on either "RESET FUSER LIFE COUNT" or "RESET TRANSFER LIFE COUNT" CLJ 8500 CLJ 8550 • Scroll MENU button to resets menu • Press SELECT button on either "RESET FUSER LIFE COUNT" or "RESET TRANSFER LIFE COUNT" CLJ4600 / CLJ4650 – CLJ5500 / CLJ5550 • With printer at ready state, scroll until "CONFIGURE DEVICE" (P) • to "RESETS" (P) • to "RESET SUPPLIES" (P) • Highlight either "NEW FUSER KIT" or "NEW TRANSFER KIT" • Press (P) then to "YES" (P) CLJ 4700 / CLJ CP4005 / CLJ 4730 MFP / CLJ CM4730 MFP This series has the fuser and transfer belt designed to automatically reset the consumable counters. Please Note: • Printers must be tuned off when changing either part • There is no way to reset either fuser or transfer count other than replacing the component CLJ 9500 With printer at ready state: • Scroll to "CONFIGURE DEVICE" (P) • to "RESETS" (P) • to "RESET SUPPLIES" (P) • Highlight either "NEW FUSER KIT" or "NEW TRANSFER KIT" • Press (P) then to "YES" (P) u *This Tech Tip is contributed by Laser Pros. Visit their website www.LaserPros.com or email any question to marketing@laserpros.com.